Ushio NSHA250JK Bare Bulbs for JVC PK-L2615U - Page 3 - AVS Forum | Home Theater Discussions And Reviews
Forum Jump: 
 25Likes
Reply
 
Thread Tools
post #61 of 72 Old 05-09-2020, 04:06 PM
Newbie
 
prongs44's Avatar
 
Join Date: Nov 2008
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked: 0
Hi Dominic,
I am looking for a bulb for my projector, I tried to PM you but not enough posts. Can you contact me please. Thanks.
prongs44 is offline  
Sponsored Links
Advertisement
 
post #62 of 72 Old 05-12-2020, 09:37 AM
Advanced Member
 
neo_2009's Avatar
 
Join Date: Mar 2009
Posts: 773
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 384 Post(s)
Liked: 296
Mine arrived today, very well packaged ... Thank you!
Mocs123 likes this.
neo_2009 is offline  
post #63 of 72 Old 05-12-2020, 10:57 AM
AVS Forum Special Member
 
nathan_h's Avatar
 
Join Date: Mar 2001
Posts: 9,701
Mentioned: 45 Post(s)
Tagged: 0 Thread(s)
Quoted: 2950 Post(s)
Liked: 2081
Cool. Glad to hear he still has them. I have a PM in to him to get one as well.


My current setup.
Recommended podcasts: The Next Picture Show, the /filmcast, AV Rant.
nathan_h is offline  
Sponsored Links
Advertisement
 
post #64 of 72 Old 05-12-2020, 11:08 AM - Thread Starter
AVS Forum Special Member
 
Join Date: Dec 2014
Location: Mississauga, ON, Canada
Posts: 8,511
Mentioned: 187 Post(s)
Tagged: 0 Thread(s)
Quoted: 6116 Post(s)
Liked: 2538
Quote:
Originally Posted by nathan_h View Post
Cool. Glad to hear he still has them. I have a PM in to him to get one as well.
Both the supply and the postal services are very erratic these days. That particular order was placed on March 01 and was just delivered today.

I am re-assessing the situation regarding new orders.
Dominic Chan is offline  
post #65 of 72 Old 05-12-2020, 11:23 AM
AVS Forum Special Member
 
nathan_h's Avatar
 
Join Date: Mar 2001
Posts: 9,701
Mentioned: 45 Post(s)
Tagged: 0 Thread(s)
Quoted: 2950 Post(s)
Liked: 2081
Fair enough! Hope it can continue but understand if it can't.


My current setup.
Recommended podcasts: The Next Picture Show, the /filmcast, AV Rant.
nathan_h is offline  
post #66 of 72 Old 05-19-2020, 01:42 PM
Member
 
alobar's Avatar
 
Join Date: May 2008
Posts: 16
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 14 Post(s)
Liked: 4
apparently my post limit is too low to send PMs.

can you PM me so i can respond with my Email for a bulb?
Thanks

Tom
Quote:
Originally Posted by Dominic Chan View Post
Note: I previously posted in the Classified section but apparently the Dealer Specials is more appropriate, according to the forum rules.
To avoid spurious notifications from being generated, please contact me by PM if you're interested, instead of replying to this thread.

FS: Ushio NSHA250JK Bulb for JVC PK-L2615U and PK-L2618U

I'm selling brand new Ushio NSHA250JK 265W bare bulbs. These can be installed in the JVC PL-L2615U/L2615UP lamp housing which is used in all recent JVC projectors (DLA-RS-400, RS-420, RS-440, RS-500, RS-520, RS-540, RS-600, RS-620, RS-640, X550, X750, X950 etc).

The same bulb is also used in the new native 4K models (DLA-RS2000, DLA-NX7 etc), in a completely different different housing. The bulb replacement procedure is essentially the same; see the last four pictures attached.

This is the 265W version of the Ushio lamp; older JVC projectors use 220W or 230W versions. Please note, however, that there are variations between lamps; I consider 15% variation to be within manufacturing tolerances.

EDIT 2020-04-24:
Mail services from Asia have been very erratic with the current situation so I'm temporarily suspending the drop ship option. Mail within North America is somewhat slower but still moving. I am bringing in the supply via courier services which results in a price change.

The cost is $110$125 USD plus $15 tracked shipping to US or Canada. Item will be shipped from Canada.

Alternatively the bulb can also be drop-shipped from the supplier, in which case the cost would be $110 USD including shipping, but will have to be pre-paid (3 weeks delivery time). This is the option I recommended for those outside North America, as the shipping cost would otherwise be uneconomical.

With either option just provide your email address and I’ll send you a PayPal invoice.

================================================== ================================================== ====

Installation instructions: It's relative easy to install the bulb into an existing housing. The only tools required are a Philips screwdriver and a pair of tweezers.

It's best to work with the lamp in the orientation shown in the picture once the 4 retaining screws are removed, as otherwise some parts may fall out.

To remove the old bulb:
- Remove screw 1 and the metal bracket that it holds.
- Remove the two screws 2 that hold the wires to the bulb terminals. Remember which wire goes where.
- Remove the four screws 3 (two shown in picture, two more at the back) that hold the brackets clamping the lamp to the housing. Lift up the four brackets, remembering the order. Lift up the bulb. There are more brackets underneath; do not remove those. Also note the small U-shaped spring in the upper right corner, which is intended to prevent the bulb from moving laterally.

To install the new bulb, reverse these steps. Make sure when inserting the brackets, the little alignment pin poke through the hole. Also make sure all brackets are resting flush against the plastic housing, before tightening the screws. If necessary, reseat the lamp so that the brackets rest flush. Make sure the screws are snug but do not over-tighten them.
alobar is offline  
post #67 of 72 Old 05-19-2020, 03:17 PM
AVS Forum Special Member
 
nathan_h's Avatar
 
Join Date: Mar 2001
Posts: 9,701
Mentioned: 45 Post(s)
Tagged: 0 Thread(s)
Quoted: 2950 Post(s)
Liked: 2081
Quote:
Originally Posted by alobar View Post
apparently my post limit is too low to send PMs.

can you PM me so i can respond with my Email for a bulb?
Thanks

Tom
If you look two posts above yours you will see that due to current world events, these are no longer shipping at present.


My current setup.
Recommended podcasts: The Next Picture Show, the /filmcast, AV Rant.
nathan_h is offline  
post #68 of 72 Old 05-20-2020, 01:48 PM
Member
 
alobar's Avatar
 
Join Date: May 2008
Posts: 16
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 14 Post(s)
Liked: 4
thanks nathan. i just saw that. ill see what happens.
alobar is offline  
post #69 of 72 Old 05-20-2020, 01:58 PM - Thread Starter
AVS Forum Special Member
 
Join Date: Dec 2014
Location: Mississauga, ON, Canada
Posts: 8,511
Mentioned: 187 Post(s)
Tagged: 0 Thread(s)
Quoted: 6116 Post(s)
Liked: 2538
Just to clarify what was said:

I have suspended drop-shipping (shipping directly from the supplier). I am continuing to ship from Canada if I can still bring in the bulbs via courier service (DHL).
Mocs123 and neo_2009 like this.
Dominic Chan is offline  
post #70 of 72 Old 05-20-2020, 01:59 PM - Thread Starter
AVS Forum Special Member
 
Join Date: Dec 2014
Location: Mississauga, ON, Canada
Posts: 8,511
Mentioned: 187 Post(s)
Tagged: 0 Thread(s)
Quoted: 6116 Post(s)
Liked: 2538
Just to clarify what was said:

I have suspended drop-shipping (shipping directly from the supplier). I will continue to ship from Canada if I can still bring in the bulbs via courier service (DHL).
Dominic Chan is offline  
post #71 of 72 Old 05-20-2020, 06:13 PM
AVS Forum Special Member
 
nathan_h's Avatar
 
Join Date: Mar 2001
Posts: 9,701
Mentioned: 45 Post(s)
Tagged: 0 Thread(s)
Quoted: 2950 Post(s)
Liked: 2081
Here’s hoping that that “if” turns from a “not now” into a “now taking orders” soon!


My current setup.
Recommended podcasts: The Next Picture Show, the /filmcast, AV Rant.
nathan_h is offline  
post #72 of 72 Old 05-23-2020, 07:19 PM
Newbie
 
Join Date: Jul 2016
Posts: 12
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 13 Post(s)
Liked: 0
Dominic can you pm me please.

Thanks
PistNBrke is offline  
Sponsored Links
Advertisement
 
Reply Dealer Specials

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page


Forum Jump: 

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off