The 2nd pic is older with the epson 5040ub. The atmos speaker holders and wires are painted flat black now and I still need to clip them up but I'm still undecided on if I'm going move all my AV electronics in the other room so I dont want to cut the wires (and I'm lazy..ha!) I have painted one and most of the other tc sounds lms ultra 5400 boxes but it's too low of humidity for them to dry with herculiner so I pulled them out of the garage and using them since I got the new rs540u. So I'll finish the boxes when humidity goes up (early spring)
Other than that I'm picking up I think was 30 yards of triple black velvet soon to do the whole back wall, 44" of the ceiling, and 6ft both sides.
I have to upgrade my 2011 klipsch icon speakers then I'm pretty much done other than some theater seats I found or a new couch. The basement was already painted a medium grey and the ceiling a dark brown.
Its fully 100% light controlled. So the black velvet is needed even with the grey walls and brown ceiling. Plus the entertainment center top is glass so that reflects also. Why I want to move the electronics. The lights are on a dimmer switch for 2 parts of the room. 3 led lights above the projector can add light during movie without really affecting the screen at low at all. Plus have a remote for it. There is a outlet by the screen that they had light lamps in between the joists? Too bright and takes out the projection. So looking for some leds or something similar to the ones I have in the back and move them behind after the black velvet will be.
Are there any good ISF calibrators around WI?
Edit.. the light is actually on the left speaker in the 2nd pic that they had up in the rafter.. there are 2 of them that plug into a electric outlet that's on a seperate dimmer switch than everything else.
Edit again.. added few more pics. 1 was how I had the x900f and the setup before going PJ. The next is when I just got my screen and pj so didnt even move the atmos speakers yet. And last is the other room where the previous owner had his HTCP setup for his home theater. Only problem is I'd have to run another dedicated outlet and breaker for my amp or the other equipment to run the fp14000 amp. It's a 20amp right now so I figure get a 30amp for the amp and put every thing else on the 20amp.
Denon X4400H Emotiva XPS-7 Balanced minidsp 2X4
Klipsch icon series FLC/surrounds, RSL C34E for .4
2 4cu sealed Tc Sounds Lms Ultra 5400s FB14000
Xbox one X, Shield 4k, sony 65" X900F, RS540U, 115" 2.35:1 HD Fury Linker
Last edited by MagnumMafia05; 02-12-2019 at 02:20 PM.