Two glaring issues with the new firmware:
1) Booting up the projector still doesn't remember the previous gamma mode (this is an issue on previous versions also)
2) Booting up the projector no longer remembers the previous source input. It boots straight to the home page. I don't remember if there was a setting in the previous menu design to enable this. If there is, I can't find it anywhere in the new menu.
I haven't had a chance to see if the picture controls in the new firmware works better than before but these are the two issues that stand out.
Chiq B5U | 100” Snowhite UST Screen | Pioneer Elite LX-503 | 7.2.4 Surround | Sony Core Series LCR + Atmos | Cambridge Min 12 Side Surrounds | Monoprice Rear Atmos Surrounds | Bic V1020 x2