How to connect resistors to the Maggies?
Thanks once again Don for your additional insights. Not that you need to, but if you look online for the resistors made by Path, you'll see that the leads on their resistors and only about one inch long, while the resistor is probably 2.5 inches long....Just doesn't work to connect to the panel.
I also appreciate your comments about the multitudes of Maggie tweaks, and am not inclined to dive too far into the rabbit hole. That said, I do have an environment where the Maggie sound is overly bright and the tweeter attenuation mitigates that - but in my case those one ohm tweeters that Maggie provides may be overdoing that. So, (and as in fact suggested by Maggie) I am looking getting resistors with a lower ohm value to end up with less attenuation. Those can be purchased directly from Magnepan, but I'm looking at other possible suppliers - but probably at this point will avoid those choices that will not be easy to connect.
Ultimately it may be that I look more into room correction and/or room treatments - but looking into resistors at lesser ohm values will not be expensive (especially if I avoid "audiophile" resistors), and I can see if that will get me closer to where I need the sound to be.
Again, I appreciate your taking the trouble to share your knowledge!