Originally Posted by CheYC
Yeah I don't have them anymore unfortunately and I've tried finding them online with no success.
I did buy the suggested mounts 2 post above, but they do not open wide enough to fit these speakers
so I need to return them. There has to be an easier way... Maybe I should looks at brackets at Home Depot or something.
Did you keep the onwer's manual? That's always a good idea. If not, from the owner's manual:
Important Safety Notes
• Proper selection of mount-ing hardware and installation of the wall brackets are the responsibility of the customer.
• This product is not intended for ceiling mounting.Two Number 8 roundhead or panhead screws should be used for each loudspeaker.
The screw head should be between 5/16" (8mm) and 1/4"(6.3mm) in diameter, and the screw should be at least 2"(50mm) in length. When installing screws in any wall, it is always preferable to screw them into a wall stud. If none is available, it is important to always use properly selected wall anchors. Attach two of the four self-adhesive rubber pads that came with the loudspeaker to the back of the enclosure in the two bottom corners so that the cabinet is spaced evenly from the wall. Select a suitable mounting location on a wall. (The ceiling is not a suitable mounting location.) Drill two pilot holes, appropriately sized for the specific self-tapping screw or wall anchor that you will be using. A template is included with your loudspeaker that indicates the proper locations fort he pilot holes. In the eventthat the template is missing, refer to this chart:
Model Distance Between Pilot Holes
L810 6" (152mm)
L820 8-1/2" (216mm)
LC21 4-1/2" (368mm)
The holes should be 2-1/4" (57mm) below where you want the top of the enclosure to be positioned. Use a carpenter's level to ensure that the holes are even and that the speaker will mount on the level. Install the two screws into either a wooden wall stud or anchor, and tighten them until the back of each screw head is about 1/8" (3mm) from the wall.
Models L810 and L820 may also be corner-mounted using the keyholes located on the bezeled corners. For corner mounting, fold the mounting template in half, place the fold in the corner at the desired height, and use the outer holes. If the template is missing, for corner mounting drill each pilot hole 7-3/4"(197mm) from the corner formodel L810, or 9-11/16"(246mm) from the corner for model L820.
Install the loudspeaker by slowly moving the cabinet toward the screws so that the screw heads clear the larger circular portion of the two key-holes. Once both screw heads have entered the keyholes, the loudspeaker should gently be lowered onto the screw shafts. Check that the loud-speaker is firmly locked ontothe screws by gently pulling thespeaker down and forward.