clechien clechien is offline
- About clechien
- Windsor, Ontario
- Mechanical Engineer / Project Manager
|09:52 AM - Bocce3 mentioned clechien in post How should I assign my speakers?
Thank you clechien and afrogt for your...
|05:30 AM - Invincible mentioned clechien in post Advice for a new multi HT, multi-room setup.
clechien - Yes, seeing as tod...
|08:40 AM - DonH50 mentioned clechien in post Speaker noise and thumping from AC power
...a local resource as clechien suggested is a good ...
|12:25 PM - heywaj10 mentioned clechien in post Large/vaulted room + built-in bookshelves: Help Needed
...'t happened yet. clechien - I tend to agree, f...
|04:45 AM - x-evil-x quoted clechien in post Mirage Nanosat mounts & Atmos setup question
Although the drivers in the M...
|06:12 PM - Jekyll & Hyde quoted clechien in post Polk PSW-505 high pass filter?
IF you use the LFE input on t...
|05:32 AM - clechien quoted Jekyll & Hyde in post Polk PSW-505 high pass filter?
Thanks! What about if I'm using the L...
|03:26 AM - Jekyll & Hyde quoted clechien in post Polk PSW-505 high pass filter?
Generally there will be no cr...
|07:57 AM - clechien quoted Jekyll & Hyde in post Polk PSW-505 high pass filter?
Does anyone know if the Polk PSW-505 h...
|09:53 PM - lovinthehd quoted clechien in post Dolby Pro Logic IIx
The listening mode you're loo...
|09:39 AM - dctootall quoted clechien in post 7.1 HTIB died, looking at advice for non-HTIB replacement
IMHO, the best way to start i...
|09:02 PM - indebtbassfreak quoted clechien in post optical vs. HDMI
Optical and HDMI can both tra...
|11:04 AM - lovinthehd quoted clechien in post Behringer a500 amp
Because not all power ratings...
|10:01 AM - clechien quoted lovinthehd in post Behringer a500 amp
So how do speakers sing with a ...
|07:56 AM - clechien quoted YonathanZ in post How to connect DAC to both speakers and sub (which are all individually amplified)
I have, I was just too lazy to...
|01:50 PM - YonathanZ quoted clechien in post How to connect DAC to both speakers and sub (which are all individually amplified)
Have you never heard of a Y-S...
|01:19 PM - clechien quoted YonathanZ in post How to connect DAC to both speakers and sub (which are all individually amplified)
I cut the 2 rca to rca male ca...
|12:23 PM - clechien quoted Espo77 in post How descrete should 5.1 audio truly be? Dolby SL decoding in to SR at low volume
Stop trying to figure the s...
|06:35 AM - clechien quoted jaddie in post Looking for more power
The amp is a 1978 design an...
|10:23 AM - clechien quoted Bocce3 in post How should I assign my speakers?
Thank you clechien and af...
|12:47 PM - ClayM325 quoted clechien in post WilL this speaker configuration work?
Would you consider doing in c...
|12:15 PM - neverwhere quoted clechien in post Speaker Location
They should work fine, issue ...
|11:58 AM - clechien quoted neverwhere in post Speaker Location
[FONT=Arial] Would on-wa...
|10:54 AM - neverwhere quoted clechien in post Speaker Location
Best position is to get the m...