AVS Forum banner
cm10
1-6 of 6 Results
  1. Speakers
    I was able to get 2 open box CM10 (S2) at a local BBY at $950 each. When connected to my Pioneer Elite receiver (SC82), the top tweeter sounds way too bright (metallic) and there is a slight hissing sound if I listen closely (can't hear it from where I sit a few feet away, though). I am not...
  2. Receivers, Amps, and Processors
    Hey Guys I'm a newbie to the higher quality Home Theater / Audio products and am looking for some recommendations. I have the Yamaha A2040 receiver (140w/channel) and a pair of B&W CM10s fronts (300w). My suspicion is that this setup could benefit from a power amp to better drive the CM10s...
  3. 2-Channel Audio
    So i brought home my first preamp today to incorporate into my dual purpose listening room/home theater and I am just doing a bit of reading before I plug it in and do my best in home comparison to using my SR7009 as the front end of my two (or 2.2) channel music setup. I went to the closest...
  4. Speakers
    so I have a 5.2 set up right now with b&w CM10s as fronts, cmc2 as center and my older infinity alpha 50s as surrounds and I noticed after calibration using audyssey a crackling or fuzzy type noise coming from what appears to be the tweeter on the front right speaker. I did buy some audioquest...
  5. Receivers, Amps, and Processors
    Hi, I was wondering what exactly I could gain from bridging a NAD C375BEE with a C275BEE amp. According to the instructions it would give me 330W mono blocks but they would also see my speakers as 4 ohm speakers (wiring for this seems to use both left and right channels together on each amp)...
  6. Speakers
    I'm finishing building a home theater and am starting to listen to speakers. I currently like the CM10's and the Revel F208's. (I can buy the F208's used for $3500). That said, my ears slightly preferred the low and mids on the CM10's, but the bass is amazing on the F208. I found my...
1-6 of 6 Results
Top