I'm looking for advice on a new receiver for some older speakers. Previously I had a 5.1 setup using a Marantz SR5002; now I'm moving the setup to a new room, adding some height speakers, and hooking it up with eARC, so a new receiver is in order. The setup:
Fronts: Focal Chorus V...
I have a brand new Denon AVR-x6700H that hasn't even been taken out of the box. I decided to go a different route, so thought I'd put this up for sell here before I send it back. The serial number is DBCY03210558 so this is one of the newer models with updated capacitors.
Since this is brand...
I am in the process of doing research for an upgrade of my primary AVR so that I can complete a broader upgrade of my entire system to 9.2.4 (the room is actually wired for 11.2.6). So far, I am anticipating purchasing the Denon AVR X8500HA so that I can get 13.2 in a single chassis. My...
A/V Receiver: DENON AVR-X1300W 7.2-Ch x 80 Watts with Networking
Left and Right Front: 2x KEF T301 Black
Center: KEF T301c Black
Surround: 2x KEF T101 White
[SOLD] Sub: SVS SB12-NSD (with SVS SoundPath Subwoofer Isolation System upgrade)
I have an older AVR-X1200W that I bought years ago and has been sitting in storage until this point. I plug the device in and have solid red light above the power button but nothing happens when I try to turn on the power by hitting the power button or using the remote.
Denon Tech Support tried...
Hello everyone, Not sure where to post this one since it straddles the fence between equipment and REW, but here it goes. I have the Denon AVR-S540BT. It's pretty basic, I know, but it usually gets the job done. However, I have been playing with REW with the UMIK-1, and I have noticed that I do...
I have Denon AVR-X1600H and Philips 439p9h monitor. I connected my laptop to Denon via HDMI (IN) and then from Denon to my Philips monitor(HDMI OUT).The issue I have is that maximum resolution that I can setup is 1920x1080, but my monitor supports up to 3840x1200.
When I connected laptop...
What is the general opinion regarding Denon receivers? I’m afraid my Onkyo is starting to fail, and I’m on the market for a new receiver😭
I’ve been looking at this 4700 for a while now and can’t find any flaw with it. Does anyone who owns it have any issues with the unit, or can...
For sale is a Denon AVR 1513 5.1 home theater receiver in great condition. Everything works properly and it comes with remote and all the original manuals.
Asking $60. Unable to ship it so local pickup only. Located in far West Suburbs of Chicago. Below are the details about the receiver
I just moved into a house with this reciever for the living room surround sound already built in. The owner says there are 2 outside speakers by the patio wired in as well but cannot figure out how to turn the outside speakers on and off. Anyone have any experience with this kind of setup??
Hello all! So Summer is nearly here and my Dad wants music in his backyard. He has a normal Denon 5.1 setup (AVR-S900W) for his home theater that he would like to take it from. Would like to take music from a few sources:
Plex Windows 10 that is plugged into the Denon via HDMI
Hi, can I use this speaker as a back or side speacher in a 7.2 System? This is the speaker:
and this is the recivier...
i have a front left, front right, front center, left and right middle ceiling speakers, and left and right back surround speakers.
the denon seems to not like this…or i just cant figure out the correct setup
if i put the two ceiling speakers in the height inputs in the back of the denon and...
Zone 1 - Basement Main TV - 5.1.2 - Connected via HDMI Zone 1 out
Zone 2 - Basement Bar TV - No Audio needed, or through TV audio only - Connected via HDMI Zone 2 out
Backyard/Outdoor Speakers are connected via Zone 2/HEIGHT2 L/R speaker posts
This past weekend had a...
I've been experiencing a problem with my Denon receiver being unable to lock-on to an Atmos signal from my Windows 10 PC. Just to provide some additional context, the PC is being run through the receiver and then to my LG CX through the eARC port, all my cables are HDMI 2.1, Dolby Access is...
I just got a AVR2700H and using that with an old TV (so no ARC / eARC). This is how I have setup:
Cable out --> AVR HDMI (CBL/SAT) ---> HDMI OUT ---> TV
TV optical out --> AVR optical in (I am not sure if this is even needed since the cable box out is connected to AVR?)
When I turn on...
It's a 9 channel reciever and has 4 height channels. I'm a little confused about the labeling though.
Height 1 L
Height 1 R
Height 2 L
Height 2 R
Is Height 1 FRONT left and right, and Height 2 REAR left and right?
Appreciate any response and help.
A week ago i replaced my old onkyo with a new Denon x1600h, and everythings been fantastic up until yesterday.
Since then three times the reciever has turned itself on and switched to internet radio.
The first couple of times i had assumed my wife was playing with the HEOS app from...
hi people !
After a lot of thought i come to the conclusion of buying the powernode 2i as amp+music player combo (use it as roon endpoint as well) but i'd like to use it also in combination with my receiver the Denon AVR-X3700H to power the speakers and sub to jump from 9.2 to 11.2 channels...