Anyone know what the issue is here?
Video clip of projector behavior
Starts up fine, then about 1:20 into boot, lamp turns off, and power LED cycles 3 slow blinks, then 3 fast blinks.
Thanks in advance
2 year ago, i had bought an i1 Display Pro, Colormunki Design and Calman Home Enthusiast and they operated well. Unfortunately, i lost my i1 and i had to bought another one on BHphoto, but this one is not detected by Calman. Everytime i open Calman, it shows me a error: Meter or...
I have bought a used W1070, succesfully used it once, and since then have had problems with overheating.
The projector shuts down after about 5 minutes of use and the TEMP light is red.
I soon realized that the front lamp fan was not running at all.
I opened the case and disassembled...
I am still using my trustworthy Philips 3575 recorder. Recently, I went to record on a disc that was only partially full, and suddenly I was unable to record on it or finalize it even though there was plenty of space left (and only a few titles so it hadn't reached its limit). At least the...
Though I am not new to this forum(follower), but this my first post. Hope I get some help here.
For last couple of months BenQ W1070 turns off randomly and I see both power and temp buttons are solid red. According to the service manual its "fan 1" speed error running at +/-25% speed...
I searched for Vizio E32-c1 but didn't find anything relevant.
I have this Vizio panel in my home office for routine work (eyesight means 1920x1080p on a large screen is just fine). I have multiple PC's / laptops I connect via HDMI to the panel.
Anytime I connect a PC or laptop...
I just set up Onkyo TX-SR313 (AVR) with Jamo A102HCS6 5.1ch home theater.
Onkyo has front USB (for audio files)
Connections as follows:
Satellite/Cable STB -> Onkyo (HDMI In)
Laptop -> Onkyo (HDMI In)
Onkyo (HDMI Out) -> TV
TV -> Onkyo (Co-Axial) - My TV doesnt have HDMI ARC. Just...
So I bought a used YSP4000 on fleabay and when I set it up using the auto setup I get a message that says the volume is less than expected and an error code 6. It emits the test tones during the auto setup but I can't get any sound out of it. Any ideas/suggestions? Can it be serviced?
My receiver is about 2 years old. Within the last couple of months, while watching cable TV, the screen will suddenly go black. We can hear the audio, but there is no picture. The picture is restored usually within 5 seconds, but sometimes it turns green and doesn't recover. The receiver's...