AVS Forum banner

onkyo tx nr727 7 2 channel network audio video receiver

  1. Receivers, Amps, and Processors
     AUDIO OUTPUT SWITCHING I have a Onkyo TX-NR727 receiver. Audio outputs are needed to a Polk Audio TL1900 5.1 speaker system AND a Sennheiser RS160 wireless headphones. I need to switch between these outputs to use one or the other separately. I have the 5.1 system worked out OK but how do I...
  2. Receivers, Amps, and Processors
    I've received great advice on a speaker thread. Now, it's time for me to get corrected a little with receivers. I love my old Onkyo. But, it isn't capable of a lot of modern fancies. So, we plan to upgrade when we move. I'm considering TX-NR717. However, the big difference between it and...
  3. Home Theater Computers
     i bought a 5.1 set of polk audio speakers , connecting the speakers is easy 2 lines BUT when i looked to the back of the sub i was confused ! what kind of wire should i use ? and connect it to where and from witch point ? and really i wasn't expecting it must be supplied with its own power ...
  4. Receivers, Amps, and Processors
    Has been a few years since wading in and buying anything new. My H/K AVR525 died, so looking for a replacement. Not even sure where to start. Sony STRDN1040 or Yami RXV1075B are looking good to me, and these seem to get good reviews from what I have seen? Using NHT SB3s x4 and the matching...
  5. Receivers, Amps, and Processors
    Greetings, All, Components: DirecTV HR21-100 satellite receiver Monoprice 8146 Component-to-HDMI converter Monoprice 7972 HDMI 1x4 powered splitter Gefen two-piece (send & receive) HDMI CAT-5e powered extender assy Onkyo TX-NR727 Audio/Video Receiver Mitsubishi HC5500 LCD...
  6. Receivers, Amps, and Processors
    I have a Denon AVR-3808CI that got hit by a lightning surge. Graphically the front panel still functions correctly. All source changes register correctly, I just have no audio or video. I'm guessing it's a blown HDMI board. A very rough estimate on repair puts it in the $250-350 range. I'm...
  7. Receivers, Amps, and Processors
     First off I love this amp, my Marantz just died.     I have my iMac hooked up through my Panasonic Plasma TV in another room then into the Onkyo TX-NR727.  What I want to know is, using Zone 2 can I have two bookshelf speakers working with a subwoofer in the same room as the iMac.  I was...
  8. Speakers
     what i bought is (onkyo 727 + polk audio tsi200+100 bookshelf +psw10 woofer ) please recommend me the wright wire and the wright connection advices . regards
  9. Speakers
    I bought an onkyo 727 AVRbut I can't decide about the speakers , I prefer 5.1 systems , my room is 5.3x6.4 m, and open with my kitchen on the long side with a 4m length opening and the kitchen + dining is 3x 6.3 m , please advices by the way I want little big speakers in size because the room...
  10. Dedicated Theater Design & Construction
    I would like to share my room, but I don't really have any pictures of the "build" because frankly, it wasn't that complicated. Its just a converted bedroom, all I did was remove the ceiling fan, paint the walls/ceiling, and install the PJ/Screen/Speakers. Right now there is a love seat as well...
  11. Speakers
     Hi, I've been following this forum for a while, and today I decided to register as I need help to make this decision. After changing receiver to a brand new Onkyo TX-NR727, I want to change the speakers as well. There are a lot of good sales now in Christmas time, and I had decided to go...
  12. Receivers, Amps, and Processors
     I'm wondering if anyone can help me understand if I need a better receiver to power my speakers.   I just bought a pair of Polk Audio RTi A5 tower speakers and a CSi A6 centre speaker with a Klipsch Synergy 12inch powered sub. I have an Onkyo NR626 receiver powering them all, I just recently...
  13. Receivers, Amps, and Processors
     So, as the title says, the HDMI output just died on my Onkyo TX-SR705. I haven't even investigated getting it repaired, but at a best I'll have to pay to mail it off to Onkyo at a minimum which will cost quite a bit. And just talked over the phone for a local A/V repair shop, it's $45...
  14. Receivers, Amps, and Processors
     I've had the 706 for roughly 5 years now and it recently broke! It appears to respond to input fine but it plays back anything and everything with hissing and popping. Doesn't matter if it's from an optical source or electrical source. It does it over all connected speakers, even the sub. I've...
  15. Receivers, Amps, and Processors
     Hi,   Doing research and so far have narrowed playing field to Onkyo NR727 or Pioneer SC-1223   They both claim to support 4 ohm speakers, but wanted opinions as to which might have limitations or which is better (or maybe basically the same?).   I have also seen that some receivers...
  16. Receivers, Amps, and Processors
    Going to replace my b&k507 with a newer unit as wife can't stand this one and having to deal with it's not automatic set up for every source.. so it'll go to my man cave.. onkyo txnr818 and the newer txnr727 both are 699 at the moment..... but seems the 2012 units where buggy. have they...
  17. Receivers, Amps, and Processors
    First let me say sorry for making another one of these "which should I buy" threads... A little background: I've been using the same over 10 year old Sony receiver and am finally looking to upgrade since I recently purchased a 65" Panasonic VT60. So, I've only been getting regular DTS or...
  18. Home Theater In A Box
     Hi,     I am new home owner and planning to setup a 7.1 system for my media room. I did some research and not sure what should I end up with. I think I am confused with the kind of over reading reviews from different people. I have a list of my own, please suggest if it would be a good...
  19. Receivers, Amps, and Processors
    I am moving to a new place and want to tidy up my HT area. Technically I'll lose my formal HT room but I'll have a nice great room to work with. The Ikea tv stand I really want to use is only about 15" deep and my Onkyo 809 is over 17. That sticks out just a bit too far so I am thinking about...
  20. Receivers, Amps, and Processors
    I'm need to get a new receiver for my new HD tv setup. I currently have and HTR-6160 which is basically the V663. It cannot pass through BTB, WTW, or 3d. I was hoping I could bypass that by using a splitter however, my HTPC's video card doesn't support splitting the signal so I need a new...
Top