AVS Forum banner
onkyo tx nr828 7 2 channel wireless network a v receiver
1-20 of 26 Results
  1. Receivers, Amps, and Processors
     Hey All, second post here... lets hope this one has more success than the first  . I am the proud owner of an Onkyo TX-NR828.  I am loving it.  Out of the box, I hooked it up as 7.1 with Surround Backs.  I experimented with PLx and PLx THX Cinema as well as THX Select2 Cinema.  I was a...
  2. Speakers
     Hey, My apologies for this if it seems stupid as a newbie, but I searched the forum and although there are bunch of posts, I dont have the time to research as much as I would like becuase my contractor is starting next week instead of May like originally planned. I have an open basement plan...
  3. Receivers, Amps, and Processors
    The 2012 model Onkyo TX-NR818 can use the pre-outs for 9.1, according to the manual. That way you can use front wide or high speakers powered by an external amplifier to get two extra channels. The Onkyo TX-NR828 is just the 2013 refresh of this model, but the manual gives no mention of this...
  4. Receivers, Amps, and Processors
    I have been through the Onkyo site and descriptions from various retailers. No where can I find if the Onkyo 828 is 3D compatible or ready. There are a number of Onkyo receivers listed on the Onkyo site that are referred to or are advertised as being 3D ready or compatible Can anyone tell me...
  5. Receivers, Amps, and Processors
    Has been a few years since wading in and buying anything new. My H/K AVR525 died, so looking for a replacement. Not even sure where to start. Sony STRDN1040 or Yami RXV1075B are looking good to me, and these seem to get good reviews from what I have seen? Using NHT SB3s x4 and the matching...
  6. Receivers, Amps, and Processors
    Onkyo TX-NR828 vs. Pioneer SC-1323-K What are your opinions?
  7. Receivers, Amps, and Processors
    This question is more specific to the equipment that I am using instead of a general question. I have a new Onkyo TX-NR828 7.2 AVR that is the base for a 5.1 HT setup that I am currently building. I have an old HK Citation 24 amp that I wanted to use instead of just storing it away. The HK is...
  8. Subwoofers, Bass, and Transducers
     I've got a bit of a weird problem with my Canton Sub 12 subwoofer.   When i turn it on after it has gone into standby mode or when i've actually shut it off, when it gets back up i will not be able to get any output from it, like it hasn't kicked in or something. From this point on i have...
  9. Receivers, Amps, and Processors
     Title says it all, and i'm looking for amp suggestions.  I've got an Onkyo TX-NR828 avr.  It states it has 130 w/c at 8ohms 2 channels, so I figure i'm only getting 37w/c with all 7 speakers right now, right?.  Either way, it's not loud enough.  I bought it because it's got 9 or 11 preouts...
  10. Receivers, Amps, and Processors
     Hello,   First time posting I am looking for some advice for my home theater for a new Receiver.  I currently am running an Onkyo SR508 that just is not doing the job anymore for my new speakers.  Front Speakers are Polk Monitor 70s, Rear Speakers are Polk Monitor 60s, Center Speaker is a...
  11. Receivers, Amps, and Processors
    I am currently looking at this receiver. Onkyo TX-NR828 7.2-channel home theater receiver with Wi-Fi® and Bluetooth® I have a 7.1 speaker surround system currently consisting of Center, Front, Surround, and Surround Back, Sub. I recently purchased the Onkyo M-5010 amplifier so I could add...
  12. Receivers, Amps, and Processors
     I think I've narrowed my search down between 2 units. I found a decent deal on a Onkyo TX-NR828 and a Marantz SR5008. I wish I could get the SR6008, but I have a credit with BestBuy and they don't offer the 6008 ATM.   The Onkyo has more features, but I have concerns with the HDMI failures...
  13. Receivers, Amps, and Processors
    I am looking at these: Yamaha rx-a 2030 Pio LX-57 Onkyo TX 828 Marantz 6008 to replace my old and retired Marantz 5006 Which of these would be most desirable and most joy to own in my 7.2 hometheatre ? PS Since I am living in Norway, these four brands are the only available, and...
  14. Receivers, Amps, and Processors
     I am a novice at hooking up stereo equipment so forgive me. I purchased a mint set of Bose 901 series VI and I am attempting to connect the EQ to the Onkyo TX-NR828 receiver but I do not see an "amp in".  Is it possible without an amp?
  15. Receivers, Amps, and Processors
    When going through the hdmi port I like the way the picture looks by raising the contrast setting slightly. With this 828 I get what I would call dithering. As I raze the setting you can see mostly in darker areas of the picture bands. Like blocks, Hard to explain but it degrades the darker...
  16. Plasma Flat Panel Displays
      am researching the purchase of a new home theater receiver to be used with a new 52" flat panel plasma TV display. It seems from my research that many of the functions of these two items are duplicated or redundant in the high end units. If this is truly the case, my question would be; is it...
  17. Receivers, Amps, and Processors
    my onkyo nr807 is toasted and the hdmi board is acting up again. i've already had it services and i've decided to get a new one instead. i'm debating between an onkyo tx-nr828 and the denon avr-x4000. i would like to hear you advise. thanks in advance.
  18. Receivers, Amps, and Processors
    I am overwhelmed with all the AVRs out there. I don't want to overspend and i am trying to get my ducks in a row for black friday in case a good deal shows up. Here is what I need it to do: A. Dual zone (powered) B. Airplay C. iPhone app for remote control D. Minimum 3 HDMI inputs and 1...
  19. Great Found Deals
     http://shop.avscience.com/Black-Friday-Specials_c_83.html Call for details .... 585-645-1006 ... but hurry as we only have 2 available.
1-20 of 26 Results
Top