Search Results for ‘panasonic tc p55vt60 55 inch 3d smart plasma hdtv’

Please help me choosing my new plasma and/or projector I have a Mitsubishi projector hc3800 and a television set panasonic 50V20 (Europe), and liked to renew my equipment. A customer for the television set for $800 appeared and I have more $1800 to spend. For the same money I have the...

Ok, I've got a Panasonic P55VT60 plasma in a family room setup. It's mounted on a Sanus LF228 arm and I've got their VMA202 soundbar bracket for it. I've had a Panasonic HTB70 soundbar on it for a few days and that's confirmed my intention to use a soundbar or similar speaker setup for this...

So my samsung plasma has developed horizontal black lines. It has been happening over the last year. However, I figured I would wait until super bowl time to pick up a new plasma. My Samsung is only 6 years old this year.. pretty pissed about it dying so early. The repair shop said it wasn't...

Hey guys, I will be buying a Panasonic TC-P55VT60 for use as my PC's monitor. I currently have a 42" Plasma TV which it will be replacing. I sit about 3 feet from my 42" TV. How far should I sit from the 55" TV? Do you think it's too big as a PC Monitor? Thanks.

I hope I can spit this question out in a somewhat understandable few sentences. On a TC-P55VT60 in the DLNA section where my movies are all listed by "date", I would like to have them listed alphabetically like they are in the computer. Any ideas how I can get this or if you even happen to...

Hey guys, I have a home theater PC and have a 42" Plasma that I have connencted that I use as a monitor in my bed room. I have the 42" Plasma sitting on a computer desk and I sit about 4 feet from the TV. I will be buying a Panasonic TC-P55VT60 to replace my 42" Plasma TV. I'm thinking that I...

 Hi Everyone.                   I'm sure this question has been asked quite a few times but I need help. I just got my 55vt60 and I have downloaded D-Nice's slides and going to run them for the 100hrs. However I can't find the recommended settings. I found the link on ControlCal and it was a...

Hello everyone, will try to keep this short. Bought a 55 vt60 and a assex entertainment center with supplied mount. After all set up I read that the tv should be 2.7 inches from wall because of heat. My mount is only 1 inch away from back of entertainment center. How bad is this? I would...

My intent for Break-In and Calibration - Part I was to clear away opinions and mis-information and intuitively supply objective information on two topics that seem filled with snake-oil and emotion. I am proud of Part I because I think there are some people who've generally learned from it; but...

I have searched all over this thread and the internet in general...someone please take a moment and help me out!!! I own a Kuro 5020. I am relatively happy with this tv. I have had it for a few years. Has anyone on this forum upgraded to the 55VT60 from the Kuro 5020? What are your thoughts...

 Hello everyone,   I hope everyone is doing well.  I've been following this site as a guest for awhile as a trusted source of information, and I have decided to finally make an account!   I've been researching for over a year now for an HDTV (I decided it is time to upgrade from my tube...

 The wife and I just purchased a 55" VT60 and I hope I'll be happy with it.  I have a Kuro upstairs and the VT will be for general viewing downstairs.  I tried to sell the wife on the 60", but it was a no go.  I also tried to sell her on the ZT, but I probably should be happy that she at least...

Now that the 50ST60's are gone, what would be a suitable replacement? The 51 inch f8500 from samsung and 55VT60 are more than I wanted to spend for a secondary TV.

 I just pulled the trigger on a Panasonic TC-P55VT60 (awesome!) I have an older home theater system, nothing fancy, just a hodge podge of stuff. I'm new here and a beginner but I'm hoping someone can help me out   All of the audio is thru RCA and the video thru HDMI   Older Panasonic 42"...

I've got a Panasonic TC-P55VT60 plasma and I'm entertaining options on which soundbar to use and how to mount it . But I'll ask the mounting question in a different thread: http://www.avsforum.com/t/1508635/mount-soundbar-with-tv-on-sanus-arm The room is wired for 5.1 speakers in the...

I've got a Panasonic 55VT60 mounted on a Sanus LF-228 arm. I'm considering getting a Pioneer soundbar for it. I'm wondering if there's a way to mount the soundbar to the arm so it turns with the TV. Is there some sort of bracket available to facilitate doing this?

 So folks, here's my predicament.   I am in the market for a new TV and have narrowed it down to a brand, Samsung. I am looking for a 48-55" LCD TV and sit about 5-10' away. So far so good, right?   What I really need help on is which model to get. I was looking at the F8000, F7500. & F7000...

I was aiming at 2.22 gamma and I came close. On Pro1 I have a calibration done with same exact variables but with BT.1886 gamma. Open to comments/suggestions. I will of course follow-up a bit once the set keeps maturing. I had a rough time of it getting the gamma controls to play nice and...

Hi, I wonder if someone can tell me if and where I can find the current number of hours on my TV. Are there any caveats to going to that section of the Menu (assuming that's what you do)? Thank you, Scott

This post is probably not going to sit well with a lot of people on here. I know that going in and I want to say upfront it is definitely not meant personally to anyone. I know these issues can get pretty heated sometimes, so I just want to present my thoughts in a balanced way and tell what...