I purchased a used Toshiba XP1 projector from a seller on the Facebook Marketplace in Dubai.
The guy is known for selling used projectors of different brands.
When he delivered the item, he powered on the device and it powered on OK.
However, thereafter it does not power up.
Here is an awesome power amplifier from Balanced Audio Technology - the VK-200.
New cost $3595.
Buyer pays shipping and fees.
It features a fully balanced circuit that has a power output of 100 watts/ch into 8 ohms.
But a power rating of a huge 1200VA says that it has much more juice!
I had a...
Hi all, I have a subwoofer in my family room that I'd like to bring to my basement once in a while when watching movies. I'd like to put it behind the couch to get more base and to feel it more and have it also act as a butt shaker. I'll need a 25 foot RCA and power cable. 20 feet would be...
Hi all, I want to mount a tv on a wall and run its power cord behind the wall, but I know it’s against code to do this. Do they make power cords that can go behind the wall? I tried searching for them but can’t find any.
Hi all, I'm looking for a surge protector. I'm looking at the Furman M-8X2 but it only says 150 Joules. most other surge protectors at a fraction of the price has 1000-3000 Joules. why are the Furmans always very low? Am I missing something here? Is it a case where I'm comparing apples to...
Hi all, I have a HT and using this APC power bar to plug everything into it. the wall outlet is 15 amp. this power bar has a yellow light to indicate when the unit is loaded above 12 amps. The light turns on even if just my PC is plugged in and the PC is turned off. Does that make sense?
I have an Epson 2150, and am having a serious issue that maybe someone can help with.
As soon as I plug in the projector, it automatically turns on. Then after about 20 seconds, it turns off. Then it turns itself back on. And then after 20 seconds, turns itself on. This cycle continues...
I recently bought a used HDP 2500 as I was running out of outlets for my little stereo / TV setup. I was previously using a Furman PL-8 II.
It seems to work great but as soon as I switch my Sumo Andromeda II (power amp) on, the “Protection ON” and the “Ground OK” LEDs turn off. Power...
I have a hand-me-down Onkyo TX-NR515 driving some equally old speakers (Cambridge Soundworks Center+Surrounds, New Large Advent Loudspeakers L and R, no sub). It’s adequate but annoying to deal with the fact that I can’t pass 4K through, so I found a used TX-SR444 for $80 that has all the modern...
I’ve finally started upgrading to some big boy toys, so naturally I fell down the surge protection/power conditioning rabbit hole.
I ended up purchasing a Panamax M5400-PM. I’m on day three, and perhaps I’m confused about the true intent of the voltage regulation properties on this device.
I starting to look at a new receiver/amp for my Tannoy SRM10b speakers. The documentation says:
Recommended Amplifier Power: 10 - 150 W (RMS per channel)
Peak Power Handling: 250 W
Sensitivity (2,83 V at 1 m):
Domestic : 93 dB
Anechoic : 90 dB
Frequency Response: 55 Hz - 20 kHz...
hello, new in this forum !
i can explain my problem below :
i have got 2 differents problem :
-first : few month ago thunderstorm paste down HDMI out, but it's not priority problem, i ll resolved later (i bought a hdmi switch temporary ..)
-second : recently, the power button "main zone" do...
I have an Inuke 6000 (no dsp, older version) that no longer powers up. The setup was 2 Inuke 6000 amplifiers that sat on top on one another with a 3/4" air gap between. The amps never saw more than 700w per channel, and even that wattage draw was rare. Both amps had the noctua fan...
I've been reading some posts about connecting external amps like Emotiva to help drive more power to LCR speakers to achieve more clarity. What I'm not sure of is if, in my setup, I would see any benefit from adding an additional amplifier. Secondarily, would it make sense to bi-amp my...
I need to figure out power stuff - both protection and backup power.
If we do a whole house surge device like a Siemens FS140 do we still need surge protection on individual devices like TV's, Apple TV's, etc.? Recommendations on whole house & individual if needed?
Good quality UPS systems...
So I built a house a few years back with automation in mind. Basically I ran all lighting romex back to a closet in my office. I have 4 15A feeds to 14 relays. The 4 feeds each feed different quad blue boxes that have insteon inline lincs in them. This was enough to pass inspection...