AVS Forum banner
speaker amplifier
1-7 of 7 Results
  1. Speakers
    I found few people discuss this setup and I like to discuss this scenario without considering other factors such as room size, quality, money, brand etc. Say I have 4 speakers (50w each) and 2 amp(50w to match) vs 2 speakers (100w each) and 1 amp (100w). Which setup will be better when...
  2. Speakers
    I am plan to get the 1582 Mkii to go with my Definitive Technology STL and or Martin Logan A11. 1. Will that over kill? seem the STL and A11 are all power speakers. 2. Will I get any benefits from 1582 Mkii to go with either STL or A11? 3. I need an Amp to hook up the miniDSP between AVR and the...
  3. Speakers
    Greetings Everyone, I recently discovered this site and believed my inquiry would be suitable here. I was wondering by any chance if anyone could please assist me, my sister is currently being harnessed by her neighbor, they live in an normal suburb and none of the houses are connected - there...
  4. 2-Channel Audio
    I have a 6 channel audio amplifier board which contains separate 6 input and out puts chanels. i have a 5.1 speaker system as well and connected all the speakers to that board accordingly. when give 5.1 (6 channel) input to that board, it works fine. . now i need to connect my phone or...
  5. Receivers, Amps, and Processors
    here is what i will be basing my choice on: http://www.svsound.com/subwoofers/sealed-box/sb-2000 what i need: 1. smaller preferred 2. lowest distortion possible 3. a remote and/or onscreen display 4. 2 speakers not mono 5. good eco/standby low power idle modes 6. a way to hook up my phone (lg...
  6. Home A/V Distribution
    Just moved into a home that has seven in ceiling speakers throughout the house. They speaker cords are located in the spare bedroom next to the family room, so if it is not very efficient set up. We had a multi speaker system in our old home, so I know we will not use them very often, however I...
  7. Audio Gear
    contact us at: [email protected] [email protected] Dolby Lake LP4D12 Processor DLP-----2100$ unit work perfectly and look great. ships in the original factory cardboard box comment 1 card with 4 analog input 3 card with 12 analog output the voltage is 100 to 240 volts...
1-7 of 7 Results
Top