AVS Forum banner
subwoofer amplifier
1-8 of 9 Results
  1. Subwoofers, Bass, and Transducers
    Hi. I have had my Mercury IXA for ages now. But lately it produces a rumbling sound on all speakers like torn speakers but I checked all speakers and they are all ok (Not torn) What could be the problem?
  2. Audio Gear
    I am selling 2 BG Radia BGX-S12B subwoofers with a BGX-A2 amp. These were designed by THX and licensed to BG Radia. They are mounted in wall (standard 2x4 studs) and are designed to project strong tight Bass with no wall vibration. They sound amazing and can be used in a very large theater...
  3. Subwoofers, Bass, and Transducers
    I tried keeping this 10-year-old thread alive but I'm thinking I might get a faster response by just posting a new one, and I think my problem might be different anyways... I found a Sony sa-wx700 on Craigslist. It was listed for $200 and I bought it for $100, so I thought I was getting a...
  4. Audio Theory, Setup, and Chat
    Hello, I appreciate this question has been asked several times before, but I am trying to seek some more information. I understand that car subwoofer amplifiers run off of 12v from the car battery, and require high amps sustained output for operation. I was then wondering, if I bought a car...
  5. DIY Speakers and Subs
    Hello guys I was looking to change my setup to a 2 subwoofer set since my new AVR does have 2 Sub EQ (denon X4300 audessy xt32). I was looking to either go with dual bic f12 - dayton sub-1200 or sub-1500 while looking for advice someone suggested a DIY sub might be the option. I know it's a...
  6. Speakers
    I think the amp is fried on my old 262 PBM subwoofer. I tried both inputs without success. The signal light never switches from red to green, and looking at the circuit board, it has several brown areas, including around both caps. This is a 150W RMS rated 12" sub. The driver has 60W 8ohm...
  7. Subwoofers, Bass, and Transducers
    Hi guys, I currently am using these subs with a kicker 400 watt amp . I believe the subs are called the EN-PK212 and all spreadsheets I can find rate them at 800 watts. There are two inputs on the back (one per woofer) so I would like to know if it would be safe to use this 1200 watt amp...
  8. Receivers, Amps, and Processors
    So I have a quite embarrassing question I need an answer to. Basically, I've been having some trouble with my subwoofer lately, and I was just setting up my sub-amp over again to make sure the amp wasn't the problem. So here comes the embarrassing part. I have the Zachry DSW-230N, and it has...
1-8 of 9 Results
Top