AVS Forum banner
troubleshoot
1-16 of 18 Results
  1. Receivers, Amps, and Processors
    Hello, I'm trying to output my laptop display from my Sony 5.1 AVR, model #STRDH590. I'm connecting up to an Epson 1060 projector. My issue is I get odd screen artifacts if I can get it to display at all. Most of the time I either get no input signal or input not supported on the projector. When...
  2. Audio Theory, Setup, and Chat
    Hi everyone, thanks for reading. I have an anthem MRX 700 receiver which I have used for years. Recently, I noticed the volume for my front right, center, back left, and surround left channels were at a much lower volume (not distorted or entirely silent just ~18db lower than the rest). I'm...
  3. Speakers
    I'm having an issue with my Patio setup and maybe someone can help a bit. It is a budget setup but it used to work reasonably well. I have noticed now a midrange distortion that is really ugly sounding. I ran some test tones and swapped out some gear with the following observations As...
  4. Subwoofers, Bass, and Transducers
    I bought a Klipsch Synergy 12" powered sub back in 2008. It has a 300W BASH amplifier. It has been connected to a 5.1 system through an Onkyo receiver for several years. I recently upgraded the receiver for a new Denon X1500H. The sub is connected with a sub cable (digital coaxial RCA) from the...
  5. Digital Projectors - Under $3,000 USD MSRP
    Hey Guys, So as the title describes I'm having issues with my NEC projector. Every time I plug the power cable into the back of it the power button will flash RED once and then have no further interaction available. There are no beeps to indicate an issue and the troubleshooting section of the...
  6. Subwoofers, Bass, and Transducers
    I've recently purchased a secondhand S10. I got it home and hooked it up to three different sources where it worked as expected...until it didn't. While listening at modest levels it simply stopped producing sound. I didn't hear any change in the sound prior to the cut out and the lights and...
  7. Subwoofers, Bass, and Transducers
    I tried keeping this 10-year-old thread alive but I'm thinking I might get a faster response by just posting a new one, and I think my problem might be different anyways... I found a Sony sa-wx700 on Craigslist. It was listed for $200 and I bought it for $100, so I thought I was getting a...
  8. DIY Speakers and Subs
    I have a pair of Ohm C2 speakers and i'm trying to restore them. One of my low tweeters doesn't work so i will have to replace that but the other one kind of works and i can't seem to figure out what's wrong with it. When i plug the connectors into the low tweeter sometimes it works sometimes it...
  9. Speakers
    I have a pair of Ohm C2 speakers and i'm trying to restore them. One of my low tweeters doesn't work so i will have to replace that but the other one kind of works and i can't seem to figure out what's wrong with it. When i plug the connectors into the low tweeter sometimes it works sometimes it...
  10. Plasma Flat Panel Displays
    Picked up a Samsung 60F8500 Plasma today for really cheap. No sound, no picture, just makes a clicking noise, turns on and off, and the red LED blinks. Screen does go bright for a second and then turn off, blinker responds too remote but that is all. Checked online, took the back off, confirmed...
  11. Audio Theory, Setup, and Chat
    Hello All! At the suggestions I got from this thread: http://www.avsforum.com/forum/89-speakers/2289330-need-help-completing-revising-motley-speaker-setup.html#post40656650 I bought this center speaker to complete my setup. And now I have left and right front speakers, left and right rear...
  12. Subwoofers, Bass, and Transducers
    i have only been able to top my svs sb 2000 out at 314w and that was with a cell phone. my marantz avr can not get it over 310w, what is wrong here. i have the avr to max db on sub and the sub knob cranked to max and the volume. when i run the avr i put it at 78.5; why can i not get higher...
  13. Receivers, Amps, and Processors
    Hello Guys, My brother made a big mistake. He accidentally connected a powered sub to the center channel speaker output of his receiver. Now , this amp is not turning on....Do you guys think the receiver is fried because of this?
  14. Digital Projectors - Under $3,000 USD MSRP
    It was all good, all fine for the last two years. And then after a 48 hour hiatus, there is no image. On switching on, LAMP goes Red POWER goes Green And it beeps back into cooled down state waiting to be switched off. Please. Help.
  15. Plasma Flat Panel Displays
    I was given a Panasonic TH-50E8PU 50" Plasma TV a couple of days ago because it no longer worked. Plugged in to power but nothing, no lights, no clicks, no pops, no smoke... Pulled the back to check for the obvious and found nothing burnt but very dusty. Cleaned out dust with compressor then...
1-16 of 18 Results
Top