AVS Forum banner
xantech
1-6 of 7 Results
  1. Receivers, Amps, and Processors
    Hello, Would anyone be so kind as to point me in the right direction. I recently bought a used Xantech MRAUDIO8X8 – Eight zone audio controller/amplifier. I am looking to implement a simple setup that just uses volume controllers in each zone, as shown in this diagram...
  2. Home A/V Distribution
    Hi folks .. I had searched and read a billion posts on this subject, but the questions I have, I have not seen any answers for - I am looking for direct user experience. I am considering one of the following systems - It all comes down to feature sets and easy of setup and use. NuVo Concreto...
  3. Remote Control Area
    I am trying to run my HTPC from both my main level and from my basement so I need to use two IR Receivers (HTPC's USB IR receiver does not work well). I have the Xantech 789-44 Connecting Block on the main level by the HTPC and in the basement I have a Xantech 490D IR Receiver spliced to Cat-5...
  4. Remote Control Area
    Hi, I've had a xantech IR repeater in my house for 8 years with almost no problems a 789-44 connecting block in my basement wired via cat-5 to an IR receiver in my family room upstairs. Occasionally it would stop taking the IR signals or my TV would beep when I changed the volume, but it was...
  5. Remote Control Area
    Hi Guys Just installed a Buttkicker LFE kit and additional transducers ( http://www.thebuttkicker.com/lfe-kit ) Their 1000W amp ( http://www.parts-express.com/pedocs/manuals/300-9440-buttkicker-bk-lfekit-lfe-manual-5591.pdf ) has a low level and a high level input. The low level is normally...
  6. Remote Control Area
    I tried searching the forums and found some similar questions, but I'm still a bit confused. Right now I have an IR receiver attached to my TV that routes all my remote IR commands to a repeater in a closet, which then sends the signal through emitters to my equipment. What I want to do is add...
1-6 of 7 Results
Top