AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
733 Posts
Discussion Starter · #1 ·
I just bought the Iscan V2 to use with my sony 1031q (replacing my VB50 and Extron 120). I am going from the 15 pin output on the Iscan to the 25 pin input on the PJ. I am making the cable myself and am in need of the pin outs. I used the pinout below (obtained from the eboyztoyz site), but only the Green lights up (I took the cable apart and rechecked the connections). I DO have composite sync set on the Iscan. The cables I was using (15 to 9 pin from VB50 to Extron, 5 BNC to 15 pin from Extron to 15 to 25 pin adaptor on PJ) all have the wrong pin combinations. The 15 to 9 cable and the 15 to 25 adaptor were made by Jason Berg. What am I missing?


HD15 -> DB25

---------------------------------------

1 -> 6 // Red

2 -> 5 // Green

3 -> 4 // Blue

6 -> 15 // Red ground

7 -> 16 // Green ground

8 -> 17 // Blue ground

13 -> 3 // Horizontal Sync

14 -> 3 // Vertical Sync


Jawhn
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top