AVS Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
4,916 Posts
Discussion Starter · #1 ·
Yup, I know it requires neg sync. And I believe that my Dish6000 has neg sync.

But here is the deal. When I turn the unit on with the RGB output of the Dish 6000 plugged into port 3, I get a "no signal" indication. If I leave the unit on in about 30-45 minutes, I start to get a singnal but it doesn't lock right awat and I get roll, After about another 15 minutes, the signal seeme to lock, but if I look closely, I can see a slight amount of gitter.

I have tested the Dish 6K and cable on a Barco 808S and it locked instantly, so I know they are OK.

If I put the Dish 6K input into ort 5, it locks instantly on the 1209.

Thanks in advance for any ideas??


Terry
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top