AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Hi there,


I just got a new RTV5040, in addition to my old RTV4000. I'd like to use

them in the same room.. however, I've come to notice that the RTV5K

and the RTV4K remotes work on the same frequency. :p


Is there a way to change the frequency for either unit?


Right now, it seems my only option is to put one of the RTVs out of

range of the other one, so I'm not aiming the remote in the same direction of both Replays. :p
 

·
Registered
Joined
·
4,839 Posts
You can use toggle mode.


Leave one on all the time....the remote power button will toggle between which unit is on or off....the on unit responds to everything else.


Alternatively you can get a remote that can output additional unit codes...


Go into setup, 243-zones and change the remote code. The RTV will then respond to 0 and the code you have selected. Alas the remote supplied does code 0, so you will need to hack, reprogram or purchase a remote that can generate the other codes.


Search around for JP1 remote sites....you can purchased one on eBay.


I used toggle mode to control my RTVs
 

·
Registered
Joined
·
463 Posts
There's a much better way if you have a Pronto remote, or any other remote that can be programmed with RC-6 commands. You can find complete instructions by clicking this link .
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top