AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I just installed the 4306 yesterday. Everything was working fine, and suddenly the OSD froze. I couldn't get out of the OSD,so I powered off the unit and powered it back on. Since then, I can't get the OSD to display unless I go to setup and change the mode from 1 to 2. When I do this, the OSD is displayed but still frozen. My setup is as follows:

Directv HD receiver --> component

Panasonic RP91 --> component

4306 to Panasonic RPTV --> component


Those are the only sources, and once I get the frozen OSD to display, it stays on the screen regardless of input. Hope someone has an idea, cause I am stumped.
 

·
Registered
Joined
·
1,431 Posts
On page 64 of your users manual it explains how to reset the microprocessor. Hopefully this will fix your problem!
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top