[DrPete]

Hi,


I am still in the midst of deciding on a receiver (everything leaning toward the 49tx) I have two subs right now, both velodyne, the older one a 12 inch sub with no adjustments on it besides volume. The newer one has cross-over adj + phase and so on. When both of these are hooked up to the 49tx and Macc is used, will it adjust the bass as best as it can and I habe to just set the volume on sub to 5 (for example) on one and keep phase at 90 on other. How is the setup in my particular case done. I dont think macc will display a smg that says please set phase at or adj x-over.Can someone inform me how macc handles this setup and how the overall setup process for my two subs should be handled if I get the 49tx (ie use macc for one sub then add other )


Thanks,


Pete


I am trying to clear up all this confusion I have regarding sub setup. Never have been able to get it right, hoping MAcc will simplify this aspect.

 

[bitkahuna]

Unless your speakers are connected to your subs, turn your crossover frequencies to max (cause the receiver will do the crossover if your speakers aren't full size).


I doubt MCACC will figure out phase, but I doubt the subs will need to be out of phase unless they're firing outward and toward eachother.


The manual says (if I remember right) just set the sub volume to 1/2 way and let it rip.

 

[rbarton]

Just an FYI, the equalizer portion of MACC does not affect the sub. Only distance and level egt adjusted on the sub through the MACC.


Bob