I have a 1031Q projecting a little less than 120" diagonally (4:3). I have the picture looking quite good except that I can see the RGB lines. I'm feeding my projector 480p. It this a result of the screen size? I used 87" diagonally previously and it was still a bit noticeable. Granted my aspect ratio was a bit stretched vertically. Would running at a higher vertical resolution fix this? I know that pushing the 1031Q past 540p gets to be very dangerous. What do I do? Just settle for the smaller screen size? Throw the electronic or mechanical focus off a bit (ha, that's what you do if you have an LCD not a CRT!) or do I just get a G90 and run 1920p . I guess squeezing the picture would help but I noticed this on an anamorphic DVD and it must be really obvious with a widescreen DVD. Thanks!