AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,948 Posts
Discussion Starter · #1 ·
Can anyone describe the layout and type of connectors for the dvi and two component inputs? (left side/right side, bottom exit, BNC or RCA; three wire or five wire for the component?)


can you send rgbhv into one of the component inputs?
 

·
Super Moderator
Joined
·
21,702 Posts
Quote:
Originally posted by jlm
Can anyone describe the layout and type of connectors for the dvi and two component inputs? (left side/right side, bottom exit, BNC or RCA; three wire or five wire for the component?)


can you send rgbhv into one of the component inputs?


all conections accessible from bottom (recessed in center: recess is 18" wide x 6" highx 2" D in back banel)


2 component video inputs 3x RCA's (no BNC) will not accept rgbhv


a single RGB VGA connector for 5 wire


DVI/HDCP connector


also RS232/speaker terminals/audio inputs/S Video/composite/power


note the master power on/off is also at the bottom of the screen (left edge)


Mark
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top