AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Got a new lamp for a bar projector(very dirty) and the new bulb worked right away and then went into the flashing red bulb indicator mode when turned on. I uninstalled it and brought it home to clean and mess around with it. It worked for me again , just one time but then returned to the indicator. It indicates a problem with bulb power supply or curcuit(vague..) according to epsons manual. I dont think its the bulb cause it is brand new but the projector worked fine up untill the bulb was replaced. Any ideas? Thanks all! Nick
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top