AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Guys been reading the AVS for a while, and have been playing with electrohomes. But i have V.Fail on a 8500 can't figure out for the life of me what it is. I have changed out of Vertical Bd Convergence the whole back plane. The control bd. Any ideas

Thanks

Coda
 

·
Registered
Joined
·
18,503 Posts
CHeck for an open yoke wire. BAd ribbon cable maybe between the back plane and the motherboard?
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
Everything seems to be in good shape. So if you have any other ideas that would help. I just put new tubes in this machine and ran it for 100 hrs. to burn in the tubes shut it down. Went back to set it up did the focus, shut it down again , and that is when V. Fail happens and won't give me high voltage.

Thanks
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top