AVS Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
739 Posts
Discussion Starter · #1 ·
Hi , I am kind of embarrassed asking this question , but i just bought a mount for the 9500LC and the bolts to attach the bracket to the projector did not come with it. so the question is does anyone know the bolt size and type(metric,non-metric, etc) that the projector takes on the projector frame to attach the mount.


Thank you


Carlos
 

·
Registered
Joined
·
2,861 Posts
I think (if I reember rigth) they are 3/8" 16TPI. Very standard at the hardware store. If they aren't the 3/8-16 then they were 5/16-18. I bought both for a whole $1 are I just can't remember which ones eneded up fitting.
 

·
Registered
Joined
·
739 Posts
Discussion Starter · #3 ·
Jay, Thank you very much , i'll buy both . you've been very helpfull.



Thanks Again

Carlos
 

·
Registered
Joined
·
4,801 Posts
Guys!


3/8" x 16, into the foot sockets.
 

·
Registered
Joined
·
2,861 Posts
Yep. I went to verify but Tim beat me to it. That was what I thought, but I also used 3/8-16 on the mount itself so I couldn't remeber. I think we can take Tim's word on it :D
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top