AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have four outdoor Klipsch speakers hard-wired to my receiver. I'm using a Nuvo Simplese to transfer audio to those speakers. Unfortunately, due to close proximity to neighbors, I can't raise the volume to adequately hear audio at the rear of our patio area. In lieu of running additional wiring, etc. I was thinking of adding a Bluetooth speaker or two to the rear of the patio. The salesman suggested I add a Bluetooth Extender to an audio out port on the receiver ensuring adequate signal transmission.

My question/concern is; Will I experience a delay between the audio transmitted via Bluetooth vs. audio to the hard-wired speakers? Thoughts/Comments?
 
1 - 1 of 1 Posts
Top