AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Managed to get my SAT-W60 caught in a upgrade loop, it appears that the Client and Boot are both stuck on Version 2545. Which amounts to dial up, try to connect to MSN and get a "All systems are busy now - maintenance"


Calling MSN and doing a 32768 did nothing and a subsequent call back basically yielded a "send it in to the factory for repairs". Have tried entering the 5309, as well as 8675309, but the unit appears to ignore these commands and simply goes on to try and dial up MSN again.


At this point, the MSN tech said somthing to the effect that the approm is "locked" in upgrade mode and that the only way to get it back to normal is return to depot.


Personally, I find it a stretch at best, but if it can be programed via flash, then it can be erased, HDD, et-all. Question is, how do I do this? most of the codes found on the list do not "flash" the leds on the front of the box like the 411 and 32768 do.


Ideas?


Thanks
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top