AVS Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
160 Posts
Discussion Starter · #1 ·
I have the Marantz SR8200 AV receiver, which has an RS-232 control port. After calling about a million different phone numbers, I got the command list and spec for the port. Unfortunately, after a lot of tinkering, I am unable to get the amp to respond to commands sent through HyperTerminal (in ASCII) or through various programs that send hex directly to the port. I am no RS-232 expert, but I've gotten my LT150 and Grafik Eye to work well with my computer's serial ports.


Any suggestions? I can post the RS-232 spec here for the amp if it would help.


Ben
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top