[RobertWood]

Can anyone out there provide me with a scan (or pdf page) of the manual's supplement pages which explain how to do the sweep reversal on a 3600/4600? According to my manual's index it's supplement S1 (which I'm missing). I know it's

accomplished by changing the orientation of the two little boards which plug into the slots on the motherboard. But I can't figure out how to plug those cards in to change my projector to front/table. The key is missing on one of the connectors. I'm not even sure if I have it installed backwards.


Thanks,


Bob Wood

 

[gn2]

Look between the green and red crt's, there's a little board there with two little boards sticking up out of it, there should be a legend etched right into the board itself which tells you the orientation of the little boards to change the pj orientation. Its the simplest and best system I've ever seen.

 

[ThurmanWitte]

Bob,


Check your e-mail. I've sent you Supplement 1 in a tif file.

 

[Matthew Todd]

Thurman, can I get you to email me the page also? I'm also trying to figure out how to do the sweep reversal.


Matt

 

[ThurmanWitte]

Matt,


Is this on your 4000? If so, I dont think it has the sweep reversal circuit board. On the later projectors with the sweep reversal circuit board, then the truth table on that board shows how the sweep reversal cards need to be installed for the 4 possible configurations for ceiling/table and front/rear.

 

[Matthew Todd]

Thanks Thurman. This is actually on a 3600. I've got both a 4000 and a 3600.


I found the truth table and the 2 cards there and figured out how to do the sweep reversal. That's actually the best system I've ever seen, very well designed.


Matt