AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
I have a new question about my AMRPO 4300... Maybe Thurman will find the solution one more time!


I'm setting up a new channel. On this channel I see the movie only with a VIDEO cable. But I think that it would be better to use a S-VIDEO source.


But I have 'NO IMPUT' message with S-VIDEO cable because I can't change with the remote control the [video pal] source to [s-video] source.


I looked for my manual and this is explained that normally you chose [A] or source. But I haven't this choice on my remote control!!! I have only [SOURCE] button and when I push it, I can see alternatively 'RGB' or 'VIDEO'.


On my last current channel, it was able to chose between 'RGB' or 's-video'.


So, how I can do a selection between 'video pal' and 'S-VIDEO' sources? Maybe I have to do a
Code:
 to inform the machine that I have a new cable for this channel?


Jerome
 

·
Registered
Joined
·
1,300 Posts
Jerome,

You need to use the source button in this case (you must have the newer style remote).

You need to push the source button until you get to video mode, a code number, and then the source button again.


Try this

[source] until the remote displays "video" and then

6[source]

to see if it will get you the S-Video


This is a list of the source numbers:

1 QUAD AUTO (auto-select - composite)

2 PAL (composite)

3 SECAM (composite)

4 NTSC 4.43 (composite)

5 NTSC 3.58 (composite)

6 S-VIDEO (auto-select)

7 S-VIDEO (PAL)

8 S-VIDEO (SECAM)

9 S-VIDEO (NTSC 4.43)

10 S-VIDEO (NTSC 3.58)
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top