AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
6,723 Posts
Greetings


I have some early musings about this machine that I have been testing a bit today.


Some initial findings.


DCDi works just fine as advertised.


There is no red chroma bug in the interlaced mode.


There is some disturbing red glowing/fluctuation in the 480P mode. Obviously some kind of bug here. The reg edges are flickering and bothersome to say the least.


The 480i section actually delivers close to 540 lines of H-resolution.

The 480P section clearly delivers the full 540 resolution. However!! There is some annoying double image in the lower half of the screen of the TVL-200 resolution pattern. All the lettering has a ghost that is about half intensity ... offset and below the actual letter. Not good at all.


The 480P section outputs some vertical line banding from edge to edge. These bands vary in colour but are about the same width ... about 4 mm each as displayed on a 47" w/s set.


I wanted to like this machine, but with these problems as noted above, the word ... "Yuck!" comes to mind.


I sincerely hope that YMMV.


Regards
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top