Joined
·
1,095 Posts
I just got my RAID controller configuration going again since one of the drives went out, so the three 100 gigabyte drives are totally empty except for the operating system. I had reported back in about October or so that there was a problem in which if you have over about 200 gigabyte of available disk space, the HiPix software would pop up with the following error message:
Run-Time Error '380'
Invalid property value
I had to get by the problem origionally by placing loads of junk files on the RAID array just to fill it up. Then, once I had enough HiPix recording on it, I removed the junk, and since I always had enough HiPix recordings, the problem never sufaced again.. until now. I had forgotten about the problem, but I just got the same message again, so the bug is apparently still in the latest HiPix Beta 2 code. I guess I'll have to spend a couple of hours filling my hard disk up with about 100 gigabyte of junk to get past the bug
.
Sean
Run-Time Error '380'
Invalid property value
I had to get by the problem origionally by placing loads of junk files on the RAID array just to fill it up. Then, once I had enough HiPix recording on it, I removed the junk, and since I always had enough HiPix recordings, the problem never sufaced again.. until now. I had forgotten about the problem, but I just got the same message again, so the bug is apparently still in the latest HiPix Beta 2 code. I guess I'll have to spend a couple of hours filling my hard disk up with about 100 gigabyte of junk to get past the bug
.Sean
