AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
150 Posts
Discussion Starter · #1 ·
I've gone through the articles dealing with this and have pretty much settled down for using the dedicated Panamorph for my G11/CS2 combo.

The only question I had was regarding anamorphic DVDs with different ARs.

Is there any difference between movies that were in 1.78 AR as opposed to 2.35 that I would need to accomodate in the scaler?

Or it did not matter what the AR was, as long as it was anamorphic, the end result (all settings being the same) would be the same.

What my worry is that since the lens would compress by 33%, a 2.35 movie might be stretched/compressed a little more or less than it should. This may be from getting confused about the Panamorph providing 1.78 from 4:3 projectors, but also providing 2.35 from 16:9 projectors.

Thanks,

SP
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top