AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,083 Posts
Discussion Starter · #1 ·
I am trying to draw up a maelstrom with two pr's, and need a narrow baffle;

Since the driver is about 18.5 wide, could I just make the baffle about 20"?

I need a footprint that is narrow, but can go back a bit, and up to get the required 8' interior. In this model I am hoping the PR's are about 9" or less flange to rear!
 

·
Registered
Joined
·
2,995 Posts
It's not the mounting depth you need to worry about, it's the 130mm long bolt and mass washers moving back and forth. If those collide you will deffinitely NOT be liking the sound. I would not offset them either. Kevin has yet to post the static depth of the PR with the full mass load, but you would need to add X-Mech to that plus a margin of safety.
 
1 - 2 of 2 Posts
Top