AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
124 Posts
Discussion Starter · #1 ·
My Barco 1208/2 has developed a problem on the blue. Now when I first start the projector, the blue shows on the screen before the picture starts. After the picture comes up it gradually becomes more and more blue. It appears to be affecting the black level of the blue. It gets brighter until the entire picture is washed out with blue. Then suddenly it returns to normal only to repeat this cycle again and again. It takes anywhere from 1 to 2 minutes for this to complete. Has anyone seen this problem before? I almost suspect something on the G2 board or maybe with the ABL circuit. Any help would be greatly appreciated.


Thanks,

Adam
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top