I seem to have developed a problem with my Barco. The picture will warp every so often like the corners will jump up then back down almost like a Matrix sort of thing. (looks like adjusting bow and keystone but ramps fast) I thought it was the scaler or resolution but it does it on every frequency and resolution (some worse than others) and with no input connected using internal patterns. If I reset everything to midpoint it seams to stop (but picture is out of focus so it may not be as obvious) after I center the rasters and go through geometry it starts and does it on all three tubes at the same time. There is also a lot of shadowing or streaking on the blue tube. Any thoughts it's watch able but annoying. I didn't notice it before so I think it just kinda of happened. Convergence seams to drift a little when this happens but very little.
Thanks
John (I am trying to get Dave Harper over to set up but I want to make sure this thing is steady before I have him set it up professionaly)
Thanks
John (I am trying to get Dave Harper over to set up but I want to make sure this thing is steady before I have him set it up professionaly)