[vertical hold]

Just finished convergence set up but I notice I am having to adjust some outer conv to 21 and 26. I set the crosshairs correctly but I would like to reset the conv to 50 and adjust it internaly. Would any one know where the adjustment for the red and blue conv board is? Thanks Bob.

 

[wireburn]

Do a search on "Barco setup". Pay special attention to the G2 setup procedure.


-Mike

 

[gn2]

Sounds like you need to set your G2 level. Do you have an option in the "Service" menu called "G2 Adjustment" ? If you do, select it and follow the directions. The green LED's are located on the board attached to the necks of each crt, and the G2 drive adjustment screws are found on the card on the far side(same side as the power cord) in the rear card compartment. They are three white plastic very small adjustment pots with the tops painted red, green and blue. If you don't have the "G2 Adjustment" option in your service menu, you can still set your G2 levels with the pots, but the procedure is more involved, and not one I'm capable or qualified to explain, You'll need the service manual for your pj for the exact procedure.

 

[vertical hold]

I found the problem, it was an oversite on my part. The line doubler had

a built in greyscale adjustment that had the red gain all the way down. Thanks for the help because I was starting to lean towards the G2 adjustment. Bob