AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
505 Posts
Discussion Starter · #1 ·
I have 2 dead barco graphics power supplies.


One fails after 30 minutes or so.

The other died when I had a short on controller and it killed it. (pinched wire to ground. fixed wire and had to install new SMPS)


Can anyone repair these.


Can anyone also give me the instructions on which caps to replace also with type/part# recommendations + where to order? I have a wiggle in raster and I'm sure it is somewhat do to bad caps in SMPS.


thanks everyone
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top