AVS Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
289 Posts
Discussion Starter #1
I read with interest the combined messages of custom resolution, specifically for the BD801 and PowerStrip. 1184X666 @ 72 was the defined "sweet spot" for this individual's projector.

Well I tried it and there was appreciable improvement in the picture. Thanks for the tip!

My question is: at the bottom of the new image are occasional flickering white dashes that move across the screen, left to right. They're not always present, but when there, they're very distracting and very bright. These are only on my HTPC.

I've read about front porch and back porch calibration. Do I need adjust any of my measurements to eliminate this flicker? Blanking will cover it, but that seemed too simple.

Any guidance? cT
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top