AVS Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter · #1 ·
I was given one of these from work, and it had a bad power supply. I sent the power board off to Barco and got it rebuilt for $225. Upon re-installing it though, the picture is way too wide, like it's a 16:9 ratio. I went into the menus and turned the horizontal width control all the way to minimum, but it still over-scans. It does this on all inputs and resolutions.


Is there an internal adjustment on this unit's chassis that will control width? I turned all the potientometers on the sweep board, but only could affect vertical functions, and convergence.
 

·
Registered
Joined
·
887 Posts
The complete procedure has been posted here maybe a year ago, but you will probably be ok just adjusting the P1 pot


Gunnar
 

·
Registered
Joined
·
49 Posts
Discussion Starter · #4 ·
aaah! the power supply board...didn't think of that. That is what I had sent out to get repaired, and they probably adjusted then....thanks guys!
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top