AVS Forum banner
  • Get an exclusive sneak peek into our new project. >>> Click Here

Barco 808 arrival

251 Views 1 Reply 2 Participants Last post by  Z-Photo
Just setup one of the 2 Barco 808 graphics and have some questions about setup. This unit has 14000 hours on the timer and the crt's are in perfect condition I'd say a 9 out of 10. Not bad for $650.00. Last night I was watching Tonight Show and is the best picture I have had to date and the focus and sharpness is not quite there yet! Brightness 30 and Contrast st at 50.



I have it about 80% setup but can't remember on how to do a G2 adjustment and focus.

It has been awhile since I had my last 808 and was looking for an old thread about setup and calibration and what order to do the steps?
Status
Not open for further replies.
1 - 2 of 2 Posts
Greg,


Go to


adjust

Service

G2


open the cover

Adjust the RGB pots (slowly - very slowly) until the green light goes off on the coresponding drive board.


Pete
See less See more
1 - 2 of 2 Posts
Status
Not open for further replies.
Top