AVS Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
hi,

I have some problems with my vertical board.

May I change my R762268 sync + vertical board (bg801 non s) by a R7622686? (I have no abl led on my rgb outputs).

Thanks

Sylvain
 

·
Registered
Joined
·
5 Posts
Discussion Starter #2
Hi,

I've picked up the R7622686 board and I'm ready do to the swap. Still anyone to tell me not to do it?

sylvain
 

·
Premium Member
Joined
·
2,101 Posts
Post a picture of the ABL LED you speak of?


check the BARCO excel file....


found at www.curtpalme.com


Some boards swop but you need other bits as well.....
 

·
Registered
Joined
·
18,501 Posts
Generally speaking, a suffix after the basic part number indicates a newer revision of the board, and should swap out no problem. Sometimes there are minor problems by putting an older board like a 762268 into a newer set using a 7622686, like bad V linearity, but you shouldn't blow anything up.


Also, I can repair the original board if that turns out to be the problem.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
thanks for the answers!

I try the board and... it works. Just put the swith on because I have no ABL.

Sylvain
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top