AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I have been working with a BG808 for a few days and can't seem to get the center of the blue tube converged. It is sharp but the pattern at the very center block has a misalignment that looks like this symbol > but to a much lesser degree. It angles to the right equally from above and below and has most misalignment at very center--like something pulling it right.


It makes the center of the picture out of convergence for blue.


Does it sound like an adjustment or something more severe?



Any and all replies will help and are appreciated.



Thanks,


Warren
 

·
Registered
Joined
·
18,507 Posts
I have not heard of this before, but I would pull out the convergence board and reseat the module.


Then go into the service menu and do a 'set to midposition' for the convergence, and reconverge.


Have you done the physical tube alignment with the convergence set to 0?


Curt
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top