AVS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
298 Posts
Discussion Starter · #1 ·
Hi,


I just get hold of a Cine 8. It can power up but unable to focus.


Anybody out there know what's the problem.


BTW after warm up for 30 minutes able to see the word but once I press the arrow to next page it will turn blur again and unable to read the words at all.


Is it the focus board or high tension cable problem?


Thanks

Began
 

·
Registered
Joined
·
298 Posts
Discussion Starter · #4 ·
Thanks, I will try changing the board.


May I know where can I download the services manual?


I only have the installation manual.


BTW just check with you guys, if I adjust the focus yoke does it going to make any different?


Cheers

Marcus Gan
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top