AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi,


Bought my first CRT Pj. an old Barco DATA P/C ( =600 ??). All looks good except for the picture width. According to the formal owner it spontaniously went smaller, without adjusting anything.


Collors, contrast etc. looks good.


I have purchased the service manual, but any help in the right direction would be appreciated.


Thx,


Mike.
 

·
Registered
Joined
·
3,137 Posts
If I recall correctly, it's from '86. It should scan to 27khz, or maybe that's the BD HR!?


I have spare-parts at home, let me know if you need it. Did you try the

width-potmetre?


Nicholas


EDIT: Just remembered, I have the older ones on the top of my closet, I will

have to lift them down when I get home, to assist you. Please tell me if

you want this, so someone else isn't doing the same thing:D
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanx Nicklas, I don't know if I need parts. Maybe it's just a transistor or something. I tried the potentiometer, but it doesn't seem to respond very much. Only the geometry changes a bit when turning it.


Mike.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top