AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
2,030 Posts
Discussion Starter · #1 ·
Some time ago I wrote about using a serial cable to automaticly change between 5/95 depending on PAL or NTSC content.


I dropped that since I didn't find any information on how to solve that without using the serial remote software (which wasn't what I had in mind).

Anyway, since I bought a Hauppage PVR card it came with a IR receiver and blaster, so my thought was if I could get the ir blaster to send the change.


Is this possible to do ?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top