AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
well I just got my behringer in today, connecting it to an avalanche 18", and I'm getting extremely low output.


Source is a Denon 1905, sub-out to the behringer. Behringer is set for bridged mono mode, input on channel one, output on the 2 binding posts labeled for mono mode.


With the volume on 0db, the gain cranked to full, and the sub-w level on +12 on the denon, I can barely get the signal lights to come on. In the meantime my speakers (powered from the denon for the time being) are quite loud at 0db.


Not sure what else to do?
 

·
Registered
Joined
·
99 Posts
Discussion Starter · #2 ·
ohh i fixed it. apparently the behringer needs both the mono AND parallel mode switches when you are briding it with only 1 input signal.


All set. Just shook my house with the avalanche freeair at -35db on the receiver. This might get kinda nuts :)
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top