AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
1,743 Posts
Discussion Starter · #1 ·
I just ordered by Benq PE8700.


What I need is the RS232 protocol document that gives the specs and all of the commands. I have the one for the BenQ DS/x660. It is very poorly written to say the least.


If any one has any experience in developing code to drive this projector through its RS232 interface I would appreciate what ever information you can share via email ([email protected]). I can't even get the CRC check code to match because their document does not state exactly how they compute it.


I am planning to use it on a unity gain screen at 133" diagonal sitting back about 20 feet from the screen. That is the configuration of my Theater.


Any experience on long DVI cables (10 meters).


Thanks in Advance
 

·
Registered
Joined
·
50 Posts
Hi Barry, for experience on 10m DVI cable, please check my comments at the end of the thread "pj demo in bay area?". Hope it helps.
 

·
Registered
Joined
·
19,586 Posts
Hey, would you be interested in doing a CQC driver for the device? If you do one, I'll give you a free copy of CQC, and you can set up a lot of other control functionality.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top